Применимость
| Модель | Двигатель | Год |
|---|---|---|
| S60 (-09) | — | 2001–2008 |
| S80 (-06) | — | 1999–2006 |
| V70 (00-08) | — | 2000–2008 |
| V70 XC (01-) / XC70 (-07) | — | 2001–2007 |
Примечание: This accessory is connected to the car's electrical system. It requires software unique to the car.
Preparations
- Turn the ignition key to position O
- Cars with manual gearboxes: Remove the ignition key
- Disconnect the battery negative lead.
Примечание: Wait at least five minutes before disassembling the connectors or removing other electrical equipment.
Applies to the V70 (00-)
- Carefully pry off the panel in front of the gear selector lever. Use a plastic weatherstrip tool as illustrated
- Move the gear selector lever as far back as possible.
Applies to the S80
- Carefully remove the panel (1) with the boot. Pry carefully using a weatherstrip tool.
Applies to the V70 / S60
- Remove the two screws from the dashboard environment panel.
Applies to the S80
- Move the gear selector lever as far back as possible
- Pull the panel (1) with the boot as far backwards as possible. Turn the panel as illustrated
- Remove the screws (2) from the dashboard environment panel (3).
- Carefully angle the dashboard environment panel out using a plastic weatherstrip tool so that it is possible to insert a couple of fingers to gain access to the side of the dashboard environmental panel
- Remove the dashboard environment panel. Pull it downward, maintaining the same angle.
- Disconnect the connectors on the reverse of the dashboard environment panel.
Примечание: If any of the outer hooks break off, these must be repaired. See the section dealing with the dashboard in the Workshop manual in VIDA.
- Remove the cigarette lighter
- Position the dashboard environmental panel as illustrated
- Detach the surround (1) by carefully pushing down the three catches (2) in the holes (3) using a small screwdriver. At the same time pry out the surround using a thin weatherstrip tool. Starting at the 12 volt socket (4), pry up one corner. The surround is tightly secured so take care not to damage any components
- Remove the surround.
Installation
- See the driver's manual for the position of the switch. Remove the switch blank. Install the new switch (1)
- Reinstall the surround and the cigarette lighter
- Connect the connectors to the dashboard environment panel. Reinstall the dashboard environment panel, see procedure ru-RU0900c8af80ffd5f6#KC01203089 and ru-RU0900c8af80ffd5f6#KC01203090
- Reinstall the panel in front of the gear selector lever, alternatively the panel with the boot.
Finishing work
- Turn the ignition key to position II
- Reconnect the battery negative lead
- Program the software according to the service information in VIDA.