Применимость
| Модель | Двигатель | Год |
|---|---|---|
| C30 | B4164S3 | 2007–2009 |
| C30 | B4184S11 | 2007–2009 |
| C30 | B4184S8 | 2007–2009 |
| C30 | B4204S3 | 2007–2009 |
| C30 | B5244S4 | 2007–2009 |
| C30 | D4164T | 2007–2009 |
| C30 | D4204T | 2007–2009 |
- Measure a distance of 225 mm (8 7/8") from the right-hand end face of the silencer and along the outer bend radius of the end pipe (where the pipe begins to be straight).
- Cut off the pipe using a pipe cutter.
- Discard the cut off section.
- Remove the cover panel on the right-hand side of the lower section of the bumper cover by pushing it forwards. It is fitted with a catch in the upper edge/rear edge. It shall not be re-used.
Illustration A
- Turn the end-pipe to the position displayed.
- Adjust the tail pipe so that the upper side of the rear edge stops 14 mm (35/64") in front of the rear edge of the cut-out in the lower part of the bumper cover.
Illustrations B and C
- Check that the lateral distance is as large.
- The position in the cut-out on the lower section of the bumper cover can be adjusted using the three screws in the end-pipe and with the screws in the two rear exhaust mountings.
- Tighten the end-pipe.
- Torque tighten the screws in the exhaust mountings if they were loosened, to 25 Nm (18.5 lbf.ft.).