Применимость
| Модель | Двигатель | Год |
|---|---|---|
| S40 (-04) | B4184SM | 1999–2001 |
| V40 (-04) | B4184SM | 1999–2001 |
Preparations
- Remove engine cover.
- Disconnect the air intake hose, see Замена корпуса дроссельной заслонки (TB).
Removing throttle position (TP) sensor
- Clean mating surfaces.
- Disconnect connector.
- Remove the two screws and lift out the throttle position (TP) sensor.
- Clean housing.
Installing throttle position (TP) sensor
Install sensor, see illustration.Turn the sensor to the left until the two mounting screws correspond to the screw holes. Finger-tighten.Position the throttle position (TP) sensor in its mid-position.Adjust the throttle position sensor, seeintxref refid="A4"
Adjusting throttle position (TP) sensor on the throttle body (TB)
Примечание: Ensure that the throttle cable is correct adjusted.
Position the throttle position sensor in VIDA vehicle communication Section 2(28) Fuel and Ignition System, Melco 1 S40/V40 B4184SM.
Install
- Connect the air intake hose, see Замена корпуса дроссельной заслонки (TB).
- Install engine cover.