iPod adapter (2001, 2002)

• Note the radio code.
• Turn the ignition key to position 0. Remove the key from the ignition switch.
• Disconnect the battery negative lead.

Примечание: Wait at least five minutes before disconnecting the connectors or removing other electrical equipment.

• Remove the rubber mat in front of the gear lever.
• Carefully prise loose the panel around the gear lever.
• Pull up the panel, unplug the cigarette lighter connector on the underside and put the panel to the side.

• Detach the radio by pressing in the catches to release them.
• Pull out the catches and pull out the radio.
• Unplug the connectors. Remove the radio.

• Remove the screw (1).
• Remove the side panel of the centre console.

• Remove the rubber mat in the storage compartment at the rear edge of the tunnel console.
• Remove the four screws holding the tunnel console in place.
• Lift out the centre console.

• Cut/drill/fill out a hole for the iPod adapter contact in the rear edge/underside of the tunnel console.

• Insert the iPod adapter cable in the tunnel console and route it rearwards on the right side of the lever assembly to the bracket for the tunnel console's rear mounting.
• Pull out the cable from the lever assembly so that its length (stretched out) is 1000 mm (40") between the contact and lever assembly.

• Take the adapter cable of the iPod adapter's power supply and route it through the radio aperture and out through the right side of the tunnel console.
• Do the same with the Melbus cable.

• Remove the backing tape on the two foam rubber guards.

• Press the a foam rubber guard onto each side of the iPod adapter's largest surfaces.

• Route the cable of the iPod adapter's power supply inside the centre console brace and plug in the iPod adapter connector.

• Route the Melbus cable of the iPod adapter inside the centre console brace and plug in the iPod adapter connector.

• Insert the iPod adapter in the space beneath the radio aperture in the centre console.

Примечание: No parts of the adapter chassis may come into contact with the car's chassis ground.

Illustrations A and B

• Wind up excess cable of the Melbus cable and the cable running to the tunnel console's storage compartment. Secure them with tie straps from the kit.
• Position excess cable within the floor mat as in Figure B.

• Position the cable beneath the tunnel console so that there is no risk that it will be pinched or chafed.
• Take the tunnel console, route the cable from the iPod adapter through the cut-out and reposition the tunnel console. Make sure that the cable is not pinched at the tunnel console's rear mounting. Make additional cuts if necessary.

• Tighten the tunnel console into place with the four screws.

• Drill a Ø6.5 mm (1/4") in the tunnel console's rubber mat for the cable grommet as illustrated.

• Make a cut between the drilled hole and the slot in the front of the rubber mat.

• Reposition the rubber mat in the storage compartment.

• Plug in the adapter cable's female connector (1) to the corresponding connector (2) on the radio.

• Connect the Melbus cable (1) from the iPod adapter and the remaining connectors to the corresponding sockets in the radio.
• Refit the radio.

• Connect the cigarette lighter contact and reposition the panel around the gear lever.
• Reposition the rubber mat in front of the gear lever.

• Reinstall the side panel and tighten it with the screw (1).

• Turn the ignition key to position II.
• Connect the battery negative lead.
• If necessary, enter the radio code.

Functionality check

• Connect an iPod unit with stored music.
• Check that the adapter controls the iPod unit: "Volvo for life" and "OK to disconnect" appear on the iPod unit display. The scroll wheel and menu buttons of the iPod adapter are locked.
• Check that the iPod unit plays. If it does not have any defined playlists, only CD 10 (playlist 10) will be played.