Steering deflection limiter 18" wheel

• Remove the front wheel.

• Unscrew the screws and remove the engine splash guard.

• Turn the wheels to the right.

• Cut away the large clip on the gaiter for the steering gear rack.

• Remove the gaiter so that the steering gear rack is accessible.

• Secure the rubber gaiter with a tie strap as illustrated.

• Take the hot air gun and warm up the spacer washer so that it can be eased over the steering gear rack.

Illustration A

• Turn the spacer washer with the rounded section of the teeth turned in towards the steering gear.
• Carefully ease the spacer washer over the steering gear rack.

Illustration B

• Reinstall the rubber gaiter in position.

• Turn the wheels straight forward.

• Take a new clip from the kit and secure the rubber gaiter.

• Make sure that the rubber gaiter and the clip are fitted in the correct positions.

• Reinstall the front wheel. Tighten the wheel nuts. Tighten to 90 Nm (66 lbf.ft).
• Repeat the operation on the other side.
• Reinstall the engine splash guard.