Применимость
| Модель | Двигатель | Год |
|---|---|---|
| V70 (00-08) | — | 2000–2004 |
| V70 XC (01-) / XC70 (-07) | — | 2001–2004 |
| XC90 | — | 2003, 2004 |
- Install the ski holder in the square section pipe on the base unit
- Tighten the ski holder using the two screws, the sprung washers and the flat washers from the base unit kit.
Illustrations A-D show how to install the lock cylinders and how to lock the ski holder
Illustration A
Illustration B
Illustration C
Illustration D
Illustrations A-G show how to lock the base unit with the accessories for the tow hitch. Use the lock housing from the base unit kit and the lock cylinder using the keys from the accessory kit
Illustration A
Illustration B
Illustration C
Illustration D
Illustration E
Illustration F
Illustration G
Illustration A
- Remove the mounting bracket for the ski holder by turning the locking knob anti-clockwise and then folding the locking knob outwards from the mounting bracket.
Illustration B
- Fold the mounting bracket outward.
Illustration A shows how to install a pair of skis
Illustration B shows how to install a snowboard
Illustration C shows how to install two snowboards
Illustration D shows securing using the rubber straps
- Slide the skis or snowboard down into the lower holder
- Hold them against the rear section of the upper holder
- Secure them against the rear section using the rubber straps (Illustration D) to keep them in place while other skis/snowboards are positioned in the holder when the mounting bracket is closed.
- Fold the mounting bracket and locking knob back into position. Tighten the locking knob.
Осторожно: Check that the load on the ski holder is secured properly so there is no risk of it falling off. Regularly check the load during the journey. The load must not obstruct the number plate or lighting. Tighten all the screws, nuts and knobs regularly to prevent any section of the accessory or the load from falling off.
The ski holder must not be used when driving off road.
Any damaged straps must be replaced with new straps.
The load must not protrude outside the ski holder.
Do not overload the car. The centre of gravity can alter when loads are transported on the hitch unit.
An extra number plate holder with lighting is available as an accessory and must be used if the number plate for the car is hidden by the loaded ski holder.