Mirrors, foldable

• Turn the ignition key to position 0.

Примечание: Wait at least three minutes before unplugging the connectors or removing other electrical equipment.

• Carefully pry off the handle using a weatherstrip tool. Start on one side.

Illustration A

• Carefully pry off the panel at the front edge of the side window.
• Remove the two screws holding the door panel.
• Carefully pull off the door panel. It is secured by surrounding clips.

Illustration B

• Detach the wire from the opening handle and disconnect the connectors.

• Remove the nut, disconnect the connector and remove the mirror.

• Carefully pry off the mirror glass.

• Carefully disconnect the two cables from the mirror glass. The glass will be reused.

• Press the mirror cover out using a small screwdriver. The cover is to be reused.

• Remove the screw holding the mirror motor.

• Detach the motor by carefully prying up the catches at the side and underneath using a small screwdriver.
• Unhook the motor from the remaining catches and disconnect the connector. The motor is to be reused.

• Carefully detach the indicator lamp from the mirror housing. It is secured by surrounding catches.

• Detach the socket with the bulb from the indicator lamp. The indicator lamp is to be reused.

• Take a new mirror housing, bulb and lamp lens for ground lighting from the kit.
• Take out the cable with bulb holder from the mirror. Press a bulb into the holder.

• Install the socket with bulb into the lamp lens.

• Install the ground lighting in the mirror housing.

• Press the socket with the bulb into the indicator lamp.

• Reinstall the indicator lamp in the mirror housing.

• Connect the connector and install the mirror motor in the mirror housing. Ensure that all catches engage.

• Install the screw to the mirror motor and tighten.

Illustration A

Illustration B

Illustration C

• Press the old cover into the mirror housing. Press all the way around so that all catches engage.

• Connect the wiring to the old mirror glass.
• Ensure that the white damper blades align in their grooves.
• Press the mirror glass into place.

• Install the new mirror.

Illustration A

Illustration B

• Check that the clips around the panel are intact and correctly positioned, they are detachable.
• Connect the connectors and the wire to the opening handle.
• Align the clips in the holes in the door frame carefully and press securely.
• Tighten the panel using the two screws, tightening torque 10 Nm (7.5 lbf.ft.)
• Secure the panel at the front edge of the side window.

Illustration A

• First secure the front edge of the handle.

Illustration B

• Then hold the handle and press on both sides.

• Download the software for the accessory's function following the service information in VIDA.