Fog lamps (2001, 2002)

• Move the left front seat to the rearmost position.

• Raise the car.
• Cut out the embossed covers (1) on the left and right-hand sides of the bumper cover.

Примечание: Cut around the outer (2) marking.
- Score around the marking in the material to create a template.
- Carefully cut through the material.
- Remove the cut-out section. Smooth the edges if necessary.

Applies to cars with air baffles on the left and right-hand sides

Remove:

• the screw (1) in the air baffle (2) on both sides.
• the air baffle by pulling backwards.

• Remove the screws (1). Slacken off the air baffle (2).
• Release the catches (3). Pull the air baffle backwards.
• Remove the air baffle.

Applies to cars from model year 2001-

Remove:

• the pre-routed connector (1) from the parking component in one of the fog lamp mountings.
• the parking component from the fog lamp mounting (it will no longer be used).
• Repeat the operation on the other side.

Applies to all models

• Install the spring nuts (1) in the holes on the left and right-hand sides.

• Install a fog lamp on the right and left-hand sides. Use the screws (1) (from the kit).

Applies to model year 2000

• Take the cable harness from the kit. Connect the short cable end (1) to the left-hand fog lamp. Connect the long cable end to the right-hand fog lamp.
• Press the cable into the two clamps (2).
• Connect the connector (3) to the pre-routed connector at the left-hand fender liner.
• Press the cable harness for the right-hand fog lamp into place under the air intake. Use the existing clamps (1). See illustration B.

Applies to cars from model year 2001-

• Connect the pre-routed connectors to the fog lamps on the right and left-hand sides.

Applies to all models

• Reinstall the air baffle(s), if applicable.
• Lower the car.

• The fuse is pre-installed for model year 2005- (CH 173000-) cars. Go to step en-GB0900c8af81dacc2e#KC08253475.
• Remove the cover (1) for the fuse holder.
• Install a 15A fuse:
• Reinstall the cover.

Remove:

• the side panel (1). First slacken off the screw clip at the rear edge of the panel. Pull the panel outward and backward.
• the soundproofing panel (2). First remove the screws (3). Then pry off the soundproofing panel at the rear edge, where it is secured using three clips (4).

• Install the relay (1) from the kit in the relay holder socket marked MI11.
• Reinstall the soundproofing panel and the side panel.

Illustration A applies only to the USA

Illustration B applies to other markets

• Remove the cover (1) on the lighting control panel.
• Install the fibre optic (2) and the button (3) from the kit. Press the button into place.
• Program the software according to the service information in VIDA.
• Check the function. Align the lamps.