Fog lamps (2001, 2002)

• Move the left front seat to the rearmost position.

• Raise the car.
• Remove the cover (1) on the right and left-hand sides.

Applies to cars with air baffles on the left and right-hand sides

Remove:

• the screw (1) in the air baffle (2) on both sides.
• the air baffle by pulling backwards.

• Remove the screws (1). Remove the air baffle (2).
• Release the catches (3). Pull the air baffle backwards.
• Remove the air baffle.

Remove:

• the pre-routed connector (1) connector from the parking connector in the fog lamp mounting.

• the parking connector from the fog lamp mounting. This will not be reused.

• Repeat the operation on the other side.

• Install the spring nuts (1) in the holes on the left and right-hand sides.

• Install the fog lamp on the right and left-hand sides. Use the screws (1) (from the kit).

• Connect the pre-routed connectors to the fog lamps on the right and left-hand sides.

• Reinstall the air baffle (s), if applicable.
• Lower the car.

• Remove the cover (1) for the fuse holder.
• Install a 15A fuse in socket number 18.
• Reinstall the cover.

Remove:

• the side panel (1). First slacken off the screw clip at the rear edge of the panel. Pull the panel outward and backward.
• the soundproofing panel (2). First remove the screws (3). Then pry off the soundproofing panel at the rear edge, where it is secured with three clips (4).

Install:

• the relay (1) from the kit in the relay holder socket marked MI11.
• the soundproofing panel and the side panel.

• Remove the cover (1) on the lighting control panel.
• Install the fibre optic (2) and the button (3) from the kit. Press the button into place
• Program the software according to the service information in VIDA.
• Check the function. Align the lamps.