AEM

• Open the boot lid/tailgate.

• Lift up the cargo compartment divider.

• Remove the covers on each side of the divider.

• Unscrew the two nuts 4 revolutions (on each side of the divider).

• Lower the divider slightly.
• Unscrew the third nut on each side of the divider four turns.

• Lower the divider completely.

• Detach the wire frame from the clip.

• Use a cable tie or the like to lock the divider's two arms on the right and left side.

• Remove the partition by taking hold of the arms and lifting upward.

Remove:

• the cover of the toolbox.
• the spare wheel, if in place.

• Take the tools out of the toolbox.

Remove:

• the clip.
• the screw.
• the toolbox.

• Remove the three screws and the lashing eyes from the floor.

• Remove the cover from the trunk lid stop. Use a weatherstrip tool to pry between the cover and the stop to release the catches.

• Remove the two light bulbs by pressing in the two catches at the top with a screwdriver.

For cars with emergency release handle in cargo compartment

• Remove the emergency release handle by pressing out the pin at the eye and unhooking the cable.

• Remove the two screws in the sill moulding.

• Remove the sill moulding by pulling it upward until the clips release. Move the sill moulding aside.

• Remove the cargo compartment carpeting.

• Remove the rubber stop on the roof's stop brace.

• Mark out the roof's stop brace in relation to the screw.
• Remove the screw and the roof's stop brace.

• Remove the load divider lock by using a weatherstrip tool to pry between the carpet and lock.

• Remove the screw and the lashing eye on the right side.

• Remove the stop brace cover.

• Mark out the stop braces for the roof in relation to the screws and nuts on the right side.
• Remove the screw, nut and the roof's stop braces.

• Undo the four clips on the side panel.

• Remove the side panel by unhooking it from the stop lug at the front edge and the pulling outward and upward so that it releases from the sealing strip.

• Plug the 4-pin black connector from the adapter wiring into the control module.

• Thread the adapter wiring through the control module bracket.

• Install the control module by fitting it on the bracket rail.

Примечание: The figure depicts a removed bracket.

Applies to cars with parking assistance

• Locate the 4-pin green connector that is taped onto the parking assistance cable harness. Connect this to the adapter wiring.
• Secure the loose connector with a cable tie.

For cars with trailer module (TRM)

• Take the green connector from the control module and connect it to the adapter wiring.
• Plug the adapter wiring connector into the control module.
• Secure the loose connector with a cable tie.

• Locate the 4-pin green connector that is taped onto the car's standard cable harness. Connect this to the adapter wiring.
• Secure the loose connector with a cable tie.

• Route the wiring along the car's cable harness all the way up to the sill moulding.

• Remove the connector (1) on the sill moulding's 12 volt socket and connect it to the cable wiring (2). Plug connector (3) into the 12 volt socket.
• Secure the loose connector with a cable tie.

Reinstall:

• the side panel.
• stops and attaching braces.
• the cargo compartment carpeting.
• the sill panel with lighting.
• any emergency release.
• the stop for the boot lid/tailgate.
• the lashing eyes; tighten the screws to 24 Nm (17 lbf.ft.).
• the toolbox.
• the partition; remove the cable ties.
• Download the software for the accessory's function following the service information in VIDA.